The MIOPS Smart+ uses connection cables to trigger your camera or flash unit. Your unit will be shipped with the proper camera and flash connection cables. The MIOPS Smart+ is a versatile device, which is compatible with many brand and models. You can use the same device with many different cameras by just changing the connection cable.
The MIOPS Smart+ has separate outputs for the camera and flash cables. Both of the output ports are located on the left side of the device under the protective cover.
The camera cable port is a 2.5 mm stereo female jack. The camera cables have the male 2.5 mm stereo jack on one end. This end is plugged into the camera connection port. The other end changes depending on the camera make and model. This end is plugged in the shutter release port of your camera.
The flash cable port is a 3.5 mm mono female jack. There is only one type of the flash connection cable. It has a 3.5 mm male jack on one end. This end is plugged into the flash connection port of Miops Smart+. The other end of the cable is a standard PC Sync port. This end is connected to the PC Sync port of the flash unit. If your flash does not have a PC Sync port, you can use a hot shoe adapter with a PC Sync port.
You can use both of the outputs at the same time. They are electrically isolated from each other. They trigger the connected device synchronously. Some older flash units require high voltages (~50 V) to be triggered. These flash units are not compatible with the MIOPS Smart+. Using such a high voltage flash unit can damage your device.
The camera and flash cables are designed to trigger the cameras and flash units only. Do not use them for any other purpose. Doing so may damage the cable or the device.