The Vibration mode is very similar to the Sound mode. The only difference is that vibration events are detected to trigger the camera or the flash.
Sensitivity:This value determines the level of the vibration that must be exceeded to trigger. The measured vibration level will we displayed in real time with orange bars. This will help you to understand where to set the threshold approximately to filter out the environment vibration. You can move the threshold bar by holding and moving circle with arrows or use "+" and "-" buttons.
Delay: This parameter defines the duration between the detection of the vibration and the triggering of the camera. You can define the delay anywhere from 0 up to 999 milliseconds.
Mode: You can select one of the two possible modes. The modes are the “Continuous Shot” and the “Single Shot”. In the “Continuous Shot” mode, the MIOPS Mobile will trigger the camera each time vibration is detected. This can cause multiple pictures to be taken or multiple triggering of the flash. If you don’t want this to happen, you can select the “Single Shot” mode. In this mode, it will trigger the camera only once, and then it will stop. You will need to start the vibration mode running again to take another picture.
The lock icon at the bottom is there to prevent accidental transactions. If you click as one tap, you unlock it. After, you can push the stop button that be active.